Paxar 4 Manuel d'utilisateur télécharger pdf (Page 31)

Printing in Continuous Mode ––––––––––––––––––––––––––––––––

In Continuous mode, the printer prints a strip of labels. The

LED should be solid amber. If the LED is solid green, the

printer is in On-demand mode. To switch to Continuous mode,

ask your System Administrator to re-configure the printer.

To print in Continuous Mode:

1. Load the labels for non-peel mode. See Chapter 2,

"Loading Supplies."

2. Make sure the host has downloaded a print job. See the

MPCL II Programmer’s Manual for more information. After

the print job is downloaded, the LED is solid amber to

indicate the printer is ready to print and labels will print

automatically.

3. Remove the strip from the printer.

Do Not jerk or pull labels strongly against the printhead. This

may cause a label jam.

Interrupting a Print Job –––––––––––––––––––––––––––––––––––––

You can use the trigger to cancel or pause the current print job:

✦

To pause the current print job (Continuous mode only),

press the trigger once. The current print job stops

temporarily. To resume printing, press the trigger

again. The LED does not indicate when the printer is

paused. The LED remains solid amber.

✦

To cancel the current print job, hold down the trigger

until printing stops. The job is canceled and the data is

lost. The host must download the job again before you

can resume printing.

You cannot cancel a print job when there is an error in the

printer until you acknowledge the error (by pressing the

trigger).

9490 Operator’s Handbook

3-4

TC9490OH Rev. C 3/97

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 53 54

Pas de commentaire

Paxar 4 Manuel d'utilisateur Page 31